Water Softener Sizing

CLICK ON PICTURE ABOVE TO ENLARGE FORMULA

INSTALLATIONS STARTING AT $100.00 * NEXT DAY INVENTORY * WE BEAT ALL ESTIMATES BY UP TO 10%

CONTACT INFORMATION:

TOLL FREE: 1-877-345-2770 LOCAL TAMPA: 813-832-9293 813-626-9498 EMERGENCY #: 813-244-5185 FAX: 813-620-0174 EMAIL: glasswatersystems@msn.com glasswatersystems@yahoo.com

PHYSICAL ADDRESS: 9402 US 92 #106 TAMPA FLORIDA 33610 (RIGHT NEXT TO STEPPS TOWING IN THE EASY AC BUILDING COMPLEX ON EUREKA SPRINGS ROAD)

WATER SOFTENER SIZING IS QUITE SIMPLE. JUST CLICK ON THE PICTURE ABOVE AND FOLLOW THE FORMULA. USUALLY WE RECOMMEND SIZING A UNIT FOR THREE DAYS CAPACITY. THE CALCULATION IS AS FOLLOWS:

WATER SOFTENER SIZING IS BASED ON THE FOLLOWING

60-100 gallons per person per day - total household use

Three day minimum between regenerations

Capacity between regenerations at factory salt settings or K label capacity

Number of people x 60 gallons per person x gpg of hardness x 3 days = capacity required between regenerations

Consult your factory representative for water that is 75 gpg or harder

(NOTE: for high volume households, use 75 gallons per day per person)

Hardness Compensation

1 mg/l of iron = 4 gpg

1 mg/l of manganese = 8 gpg

Maximum iron is not to exceed 1.5 mg/l total iron

Recommend the addition of a Res-Up feeder when the total iron exceeds 0.5 mg/l Water Softener - Iron Removal

Combination Units

This unit should be recommended only when dictated by special circumstances or the needs of the customer.

The customer should be made aware that a separate iron filter and softener is preferred because it is a more efficient way to deal with the water.

When recommending a combination unit, follow the guidelines provided in the specifications.

Water Consumption for Regeneration The volume of water used during the regeneration process of a water softener will vary depending on:

Amount and type of resin

cycle time settings

Flow controllers

Salt settings

Tank diameter

Generally, water usage for regeneration is based on the cubic feet of resin per water softener from a low of 30 gallons of water per cubic foot, up to a normal of 75 gallons of water per cubic foot, to a maximum of 100 gallons of water per cubic foot. Manufacturing specs and settings for each model size should be checked to verify exact amounts. Three Day Sizing Method

The three day sizing method is used for the following reasons:

To determine the size of the water conditioner to be used

To allow for reserve capacity between regenerations so the customer does not run out of soft water

To provide the most economical operation cost

WE CAN ALWAYS HELP WITH SIZING JUST EMAIL: glasswatersystems@msn.com

CONTACT INFORMATION

TOLL FREE: 1-877-345-2770 TEL: 813-832-9293 813-626-9498

FAX: 813-620-0174 ADDRESS: 9402 US 92 #106 TAMPA, FLORIDA 33610